日本語
****
No clean flux VS washing
1011
1
Mar 27.2019, 09:32:22
Currently the PCBA are washed after they are assembled, The assembly house requested to use no clean flux,
comparing the two process what are the disadvantage/ advantages and what types of problems should I look out fore? 
thanks
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Mar 28.2019, 11:06:10
If you have high impedance circuits, the no-clean flux residue can absorb moisture and sometime later become conductive.
Also, if the equipment is operated in a dirty environment, the flux can react with the airborne contaminants and cause similar problems.
But, if you can get away with no-clean, then it saves a whole process after stuffing and reflow. I make most of my boards with no-clean, and they do fine except in special cases mentioned above.
